Grundig 800 MILLENNIUM User Manual download pdf (Page 18)

MEMORY FUNCTIONS

MEMORY DESCRIPTION

The SATELLIT 800 MILLENNIUM contains 70 memory

locations that can be used to store and recall commonly

monitored frequencies. These 70 locations are divided

into blocks of 10, ie. 00-09, 10-19 20-29, etc. This allows

convenient grouping of frequencies. As an example, 00-

09 could be AM broadcast stations, 10-19 could be FM

broadcast stations, 20-29 could be various time stations

such as CHU and WWV, etc. With memory locations

programmed, you can use the SCAN function to

automatically monitor desired memory frequencies. The

following operating parameters may be stored in any

memory location:

(I) Frequency, (2) Mode, (3) Bandwidth, (4) AGC setting,

(5) Attenuator, (6) Synchronous detector.

STORING A MEMORY CHANNEL

First, be sure that the SATELLIT 800 MILLENNIUM is in

the VFO mode (MEMORY or SCAN not displayed). If

required, press the

button to place unit in the

VFO mode.

(A) Select the desired frequency, mode, bandwidth, etc.

(B) Press the button. 'MEMORY' will light and

the memory channel number will flash for approximately 3

seconds. While it is still flashing, enter a two-digit number

from 00 to 69. A confirmation beep will be heard. (C) The

receiver will return to the VFO mode and the last used

memory location will be displayed in the 'MEMORY'

portion of the display.

RECALLING A MEMORY LOCATION

To select a specific memory channel, press the

button. This will cause 'MEMORY' to light on the front panel

display, and the MEMORY channel number will flash for

approximately 3 seconds. While it is still flashing, enter a

two digit number of the desired memory channel to be

received. Make certain that the successive button

depressions are made within 3 seconds of each other. Other

memory channels may be selected by pressing the

button and entering two digit

numbers. If a channel number is selected that is empty,

'Error' will flash.

The large 'TUNING' knob may be used to tune from the

frequency that was stored in the selected memory channel.

The 'MEMORY' symbol turns off, but the last memory channel

number still shows. Pressing the

button will cause the

receiver to return to the last selected memory channel

number and the 'MEMORY' symbol will turn on.

DELETING A MEMORY LOCATION

Select the memory channel to be deleted as described in

'RECALLING A MEMORY LOCATION'. Press and hold the

button for 3 seconds. A beep will be heard to

indicate that the contents stored in the selected memory

channel number have been deleted.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Comments to this Manuals

No comments

Grundig 800 MILLENNIUM User Manual Page 18

Comments to this Manuals