Grundig 800 MILLENNIUM User Manual download pdf (Page 24)

SPECIAL USE FEATURES AND FUNCTIONS

The SATELLIT 800 MILLENNIUM receiver has several

special features that are referred to in the main body of

this Owner's manual but may require additional explana-

tion.

LOCK ALL ENTRY TO KEYPAD

The receiver front panel buttons with the exception of the

button and 'TUNING' knob may be locked or

disabled by pressing and holding the

button for 3

seconds.

Press the

button and hold for 3 seconds. A

confirmation beep will be heard when the

pressed. will appear on the front panel display

after 3 seconds to indicate that the front panel buttons and

TUNING control are locked.

Press again for 3 seconds to unlock the front

panel buttons and tuning control. The beep will again

be heard when the button is pressed and the

indicator on the front panel display will disappear

after 3 seconds, indicating that the TUNING control

and front panel buttons have been released.

BROADCAST BAND TUNING STEP SIZE

In the AM broadcast band, the SATELLIT 800

MILLENNIUM receiver increments the frequency in

10 kHz steps when pressing the

and buttons.

The 10 kHz step size is practical for tuning the U.S. and

Canadian broadcast bands. However, the step size can

be changed to 9 kHz to permit practical tuning of Euro-

pean broadcast stations. The tuning step size is held in

nonvolatile memory and thus is not lost during power

failure or battery changing. To select the alternate step

size:

With POWER OFF Press and hold the

button

while pressing the

button to put the SATELLIT 800

MILLENNIUM receiver in the POWER 'ON' mode.

If the step size was 10 kHz prior to performing the above

procedure, then the 9 kHz step size for the broadcast band is

now programmed. To change back to 10 kHz, repeat the

same procedure.

DELETE ALL MEMORY CHANNELS

If it is desired to delete all programmed memory channels,

perform the following procedure:

With POWER OFF, Press and bold the

button

while pressing the

button to put the SATELLIT 800

MILLENNIUM receiver in the POWER 'ON' mode.

Hold the

button until a confirmation beep is heard

to indicate that ALL memory locations have been cleared.

AUTOMATIC BANDWIDTH SETTING WITH MODE

SELECTION DISABLE (ENABLE)

The SATELLIT 800 MILLENNIUM receiver permits automatic

setting of the bandwidth appropriate for each mode of

detection. For example, 6.0 kHz bandwidth would be

selected automatically for AM mode operation, and 2.3 kHz

bandwidth would be selected for SSB mode. Of course,

pressing the 'BANDWIDTH' button temporarily overrides the

automatic setting until a mode change is made. The setting,

automatic or manual bandwidth selection with mode, is held

in nonvolatile memory and is not lost during power loss or

during battery changing. To disable the automatic bandwidth

with mode;

With POWER OFF, Press and hold the 'BANDWIDTH'

button while pressing the

button to put the receiver in

the POWER 'ON' mode.

To enable 'Automatic Bandwidth Selection with Mode'

operation, repeat the same procedure.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Grundig 800 MILLENNIUM User Manual Page 24

Comments to this Manuals